The main raw materials of tugboat fenders are natural rubber compound and rubber nylon cord, which can avoid tearing, damage, scratching, puncture and other parts during use. Our rubber fenders are repeatedly used and maintained. Even if the fender is divided into two parts, the service characteristics can be restored. The specific behavior is as follows: you need equipment & tools, the binder mixture, and mouth-shaped bracket
Repair method
1. Use a sander to clean the damaged position of the repaired fender, clean the residue with a brush, then flatten the fender and apply glue.
2. According to the size of the overlap, place the repair material (suspended rubber cord cloth) horizontally and vertically, and put the outermost layer in the fender so that it can be applied to the middle of the rubber sheet (pure rubber sheet) and brushed.
3. Put the heating plate on the repair material, put the jack on the heating plate, and then lift the jack to the top of the mouth-shaped bracket.
4. Press the jack until it is pressed by hand.
5. Turn on the power and activate the start button on the control cabinet to start maintenance.
6. When the temperature is reached, the heating device automatically stops. After stopping, the temperature of the heating plate rises, then the temperature drops and drops below 80°C, and the repair is completed.
7. Remove the jack, remove the heating plate, and then repeat the above steps to repair the damaged fender.
Leave A Reply
Your email address will not be published. Required fiels are marked